My book also says # 3 drill....which is .2130 inches.....which is
5.4102mm.....so I'd say close enough with the 5.4mm drill!
Locktite the socket screws with red Loctite and fuggadaboutit....clean 'em
out nice though with some cancer causing solvent.
Geoff Branch.
----- Original Message -----
From: <Daniel1312@aol.com>
To: <JNBrashear@garverengineers.com>; <spridgets@autox.team.net>
Sent: Tuesday, June 13, 2006 4:55 PM
Subject: Re: Drills, taps and hardware
> Hi Jack,
>
> Thanks though this side of the pond that means I need a 5.4mm or 5.5mm
> bit?
>
> Daniel
|