spridgets
[Top] [All Lists]

Re: Generator bench test

To: "Frank Clarici" <spritenut@comcast.net>,
Subject: Re: Generator bench test
From: "Mark" <mark@nashvilletn.org>
Date: Thu, 15 Jun 2006 22:21:34 -0500
Frank,

Tie the two terminals on the generator together, put test leads on the 
junction of the two terminals and the other on the case.  Then spin it, a 
good one will give you about 20-25  volts.

Mark
Nashville



----- Original Message ----- 
From: "Frank Clarici" <spritenut@comcast.net>
To: "Spridgets" <spridgets@autox.team.net>
Sent: Thursday, June 15, 2006 8:35 PM
Subject: Generator bench test



I hope I am doing something wrong or I have 7 dead generators.
I thought if I spun it with an impact wrench I would get some volts out
of the back of it.
4 of them showed almost a whole volt, 3 of them didn't make the dial wink.
I got .86 volts out of the best genny. I was sort of hoping for maybe 14-18?
I put the probes on the large teminal and grounded the other to the
generator. Spun it with the impact wrench which goes pretty fast but I
can't count the rpms.
Am I doing something wrong?
Or do I have a bunch of genny cores?
-- 
Frank Clarici
Toms River, NJ




<Prev in Thread] Current Thread [Next in Thread>