Take a look at this:
http://www.teglerizer.com/fi/GT6_manifold/ms_gt6_manifold.html
It was made for a GT6, but the principles are the same for the 1500.
-=Chris
Chris King
http://home.comcast.net/~kvcbk/
<-----Original Message----->
From: derf [derf247@gmail.com]
Sent: 1/8/2007 5:01:09 PM
To: cyrille@hp.com;cyrille@hp.com
Cc: spridgets@autox.team.net
Subject: Re: Steel versus Aluminum manifolds
If you were doing an A Series motor I would suggest you get a single SU
intake and run a single throttle body type injector. The Siamese ports
on
the A make things funky for injection. But, since you mentioned Strommy,
I
assume you are doing a Spitfidget. There is no reason you can't make an
intake manifold from steel or stainless steel. Use a gasket as a
pattern,
cut a 1/4" or 3/16" plate and ............ You get the point.
If you come up with a nice port injection system it would be easy to
plug a
blower into the system and have some real fun.
Cheers,
Derf
|