Yes of course. Get some plastic tubeing from the hardware. Use dikes and cut
it in half inch lengths and push over the pins on the grill.
----- Original Message -----
From: "Dean Hedin" <dlh2001@comcast.net>
To: "Spridgets" <spridgets@autox.team.net>
Sent: Sunday, June 08, 2008 8:15 PM
Subject: [Spridgets] Bugeye grill fasteners
>I was pulling the parts off my bonnet in preperation for paint today.
> Those little sheet metal nuts holding the front grill on were a pain to
> remove.
> In some cases they were not doing such a great job anyway.
>
> Has anyone come up with an alternative?
>
> I thought I would make up something like this. Little cylinders with a
> hole
> down the center and a set screw coming in from the side.
> Sort of like little drill stops.
>
> Do the same for the rear arrow too..
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as jlaird237@cox.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG.
Version: 8.0.100 / Virus Database: 270.0.0/1489 - Release Date: 6/7/2008
11:17 AM
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|