spridgets
[Top] [All Lists]

Re: [Spridgets] Hand brake cable

To: "'Woerpel'" <dwoerpel@wi.net>, "'Spridgets'"
Subject: Re: [Spridgets] Hand brake cable
From: "Duncan Sinclair" <duncan@pondhop.com>
Date: Fri, 21 Aug 2009 21:06:59 -0500
I tried to use the hardware store nylon washers when I assembled mine but
they were just a bit too thick to get two in there. I ended up using some
small pieces of felt. Will see how they last when this thing eventually gets
on the road.

Duncan


-----Original Message-----
From: spridgets-bounces@autox.team.net
[mailto:spridgets-bounces@autox.team.net] On Behalf Of Woerpel
Sent: Friday, August 21, 2009 5:11 PM
To: Spridgets
Subject: Re: [Spridgets] Hand brake cable

Dave,

Yes I have.  Piece of cake, or leather.  Fairly thin pieces as you need 
2/side.  Rubber or nylon washers might work as well but leather was used 
to help retain a SMALL amount of oil (I use silicone spray.). 

Dave W.



David Lieb wrote:
>> There are universal brake cable adjusters, if you have room. Take a
picture
>> of this into your FLAPS.  Bill in Oregon
>>     
>
> Speaking of handbrakes, I am getting tired of the jingle behind me
> from the e-brake rods. Anyone made replacement leather washers for the
> pins? Anything else to make them from?
> David L
You are subscribed as duncan@pondhop.com

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>