How would it help if you did all the tracings of openings of the dash on the
garage wall?
Just wondering.
Later, Paul A
----- Original Message -----
From: "Robert Evans" <b-evans@earthlink.net>
To: <spridgets@autox.team.net>; <bugeye@yahoogroups.com>; "'MarkGlevicky'"
<mmg@cinci.rr.com>
Sent: Monday, October 05, 2009 7:10 PM
Subject: Re: [Spridgets] TIps on reinstallation of recovered dash
> I have an extra Bugeye dash hanging in the garage. Would it help if I did
a
> tracing of all the openings, bolt holes, etc.?
>
>
>
> Buster Evans
>
> Anaheim CA
>
>
>
> From: bugeye@yahoogroups.com [mailto:bugeye@yahoogroups.com] On Behalf Of
> Mark Glevicky
> Sent: Monday, October 05, 2009 6:29 PM
> To: bugeye@yahoogroups.com
> Subject: Bugeye/Frogeye Club..... Re: TIps on reinstallation of recovered
> dash
>
>
>
> spridgets@autox.team.net Mark Glevicky [mmg@cinci.rr.com]
>
> Thanks guys for the good tips on dash reinstall.
>
> Now, more confusion on my part. This dash was a MKII dash originally and
> I'm making it back into a Mk I. I, of course, want to make sure everything
> is placed as it should be. So to that end, I looked in the AH Driver's
> Handbook (printed in England and says applies to Mk 1 and II) and also
cross
> checked with the pic in Terry Horler's restorers guide. They don't agree!
> The one in the Horler book admittedly is RHD (mine's not), but if I
compare
> the general layout with what's drawn in the AH Driver's Handbook (for Mk I
> RHD) they are not the same.
>
> Horler's dash, after the tach, shows only the starter, turn signal lever,
> and chock across the top (from driver side over). The AH book shows
> starter, heater, turn signal lever, Windscreen washer, and choke.
>
> Across the bottom row in Horler it's heater, ignition/lights, wiper, and
> windscreen washer. The AH book shows ignition/lights and wiper. Can anyone
> clear this up please?
>
> Second question - I'm also replacing the flasher unit in this car because
> the old one has obvious overheat indications The terminal with the dark
> green wire has the plastic cover (that covers the wire clip that attaches
to
> the flasher terminal) completely melted and has a brown burned tint to it.
> Any ideas on what would have caused this to happen...before I just put a
new
> flasher unit in?
>
> Thx, Mark
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as pasgeirsson@worldnet.att.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|