Linda,
Is it this one?
http://www.mtmc.co.uk/prodtype.asp?cookiecheck=yes&PT_ID=12707432
If you go to http://www.mtmc.co.uk/ and follow the links you'll find quite
a few listed.
http://tinyurl.com/yfkvmud
will take you to a UK Black & Decker listing that may show an exploded view
you could use as a format for the rebuild.
One of my favourite 'tricks' is to replace the brushes the wrong way round
and one of the corners between the side and working surfaces wedges between
one of the armature gaps. (red face!) You could try lifting the brushes
and seeing if it spins....
Best of luck,
Guy R Day
----- Original Message -----
From: "Linda Grunthaner" <grunthaner@gmail.com>
To: "Spridget list" <spridgets@autox.team.net>
Sent: Tuesday, October 27, 2009 1:51 AM
Subject: [Spridgets] Not LBC, tool assembly drawings for tool repair needed
> List,
> I have looked for months and I can't locate the exploded view of an old
> (30
> years) Black & Decker circular saw of mine. It was my dads and I took it
> apart and can't get it back together to where it spins by hand. I am not
> 100% sure I have it together correctly so I need the drawings. Does anyone
> know of an old tool repair shop or site I can get that from? The saw works
> fine I overlooked a split in the wire before I took it apart. If it wasn't
> my dads I would have made a lamp out of it by now but I am somewhat
> determined to get it together correctly because it worked great days
> earlier.
> Lin
> PS With all these throw away tools from Harbor Freight these days all the
> repair shops are gone.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|