spridgets
[Top] [All Lists]

Re: [Spridgets] Boot bumpers

To: spridget list <spridgets@autox.team.net>
Subject: Re: [Spridgets] Boot bumpers
From: Bill Masquelier <billmasq@hotmail.com>
Date: Tue, 9 Nov 2010 15:19:38 -0800
If you do put the bumpers on I have found that it is a real good idea to cut a
notch out of them on the bottom-rear part so that rain water won't get caught
between then and overflow into the trunk! Xacto knife works well for this.
BillM

> From: haynes386@netzero.net
> Date: Tue, 9 Nov 2010 18:20:24 +0000
> To: spridgets@autox.team.net
> Subject: [Spridgets] Boot bumpers
>
> So in reassembling the MKII, I've run into a bit of a conundrum. I've never
> had a boot seal so this is uncharted territory for me. I have new, repro
boot
> seal and bumpers. The seal goes on fine alone as do the bumpers, however,
when
> I put the bumpers in, I can't get the seal edge past the upper bumpers
> (closest to the cockpit). I've tried putting the bumpers in after the seal,
> and get the same result. There seems to be too little room in the channel
for
> both of these to exist. WTF?
> Do I trim the seal edge to allow the bumper or vice versa? or am I just
> missing something stoopid?
> "my momma always says, Stoopid is as stoopid does"
>
>
> Mark Haynes
> HAN6L12977
> HAN5L8016
>
> ____________________________________________________________
> $350,000 Life Insurance
> Coverage as low as $13.04/month. Free, No Obligation Quotes.
> http://thirdpartyoffers.netzero.net/TGL3231/4cd99159934131382c7st05duc
> _______________________________________________
>
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/spridgets/billmasq@hotmail.com
_______________________________________________

Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>