Shifting rod detente
Paul Van Wig
Long Beach/Big Bear
pvanwig@Mac.com
Sent from my iPhone
So forgive the spelling (tiny buttons)
On Sep 28, 2011, at 3:26 PM, Kirk Hargreaves <khargreaves2@gmail.com> wrote:
> Mark,
>
> The couple of times I have had my rib case out with the engine (I always
> pull the two together).
>
> There were balls or dowel shaped metal plugs and springs as I recall that go
> into the side . . where the right side of the side plate will have a gasket
> over it in place before putting the side plate back on.
>
> It has been a good while . . I may not be describing this very well . . but
> I think you know what I am talking about.
>
> I made sure that they went back in the way they were as one came out and did
> an Indian war dance across my garage floor.
>
> What are these for? Again. . the ones that go into the holes drilled into
> the side plate gasket area on the right side?
>
> Just curious as no doubt these are important to the gear box at some level.
>
> Thanks,
>
> Kirk
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|