spridgets
[Top] [All Lists]

[Spridgets] Engine Test Stand

To: spridgets@autox.team.net
Subject: [Spridgets] Engine Test Stand
From: Tim Collins <thcollin@mtu.edu>
Date: Tue, 27 Nov 2012 21:30:20 -0500
Delivered-to: mharc@autox.team.net
Delivered-to: spridgets@autox.team.net
I have been working on an engine hot test stand using whatever I had 
in the garage in the way of salvaged materials. The basic frame is 
made from steel framing studs that I picked out of a construction 
dumpster. I guess you could say I made it out of 2x4's except they 
are steel. Most folks would have gone for larger steel tubing but a 
goal was to use what I had and to practice my welding skills on thin 
steel materials.

I have a set of pics on Flickr at: 
http://www.flickr.com/photos/12702006@N07/sets/72157632115840269/
These pics show the construction from many stages of construction and 
from various angles.

The project is to the point that I have to dress out the engine, 
plumb the wet lines, and hook up the electrical, controls, and 
gauges  (which I don't have yet).

Don't ask why. This is just a project to keep me busy. I plan to use 
it to practice my tune up skills and this setup makes it easier to 
fiddle around with the distributor and other stuff. The engine is an 
"extra" that I picked up in a parts purchase so a test stand will let 
me assess the "health" of the engine.

Tim Collins
------------------------

spridgets@autox.team.net


Archive: http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>