I have a 110 wire feed welder, I have used it once or twice, but am no
where near proficient with it. I was decent with arc, and acetylene, but
have not had excuse to work with the wire feed yet.
On Mon, Jul 14, 2014 at 3:13 AM, David Camp <email@example.com> wrote:
> I feel your pain Brad.
> I replaced the axle I broke last week while pulling out of my driveway and
> also replaced the wheel bearings while I was at it. Drove to a friend's
> house to put it on his lift to check for leaks, and found the front sway
> had pulled both mountings out of the frame rails. I guess it's time to
> learn to use the welder a neighbor gave me.
> Dave Camp
> -----Original Message-----
> From: Spridgets [mailto:firstname.lastname@example.org] On Behalf Of
> Sent: Sunday, July 13, 2014 10:19 PM
> To: Yahoo Spridget list; Spridget list
> Subject: [Spridgets] Broken Axle Blues
> So, last weekend, I replaced the axle. not that bad a deal, and rebuilt the
> wheel cylinders while it was apart.
> Got ready to go on a test drive, and there was no clutch. Got it bled, and
> took it ofr a ride. All was well. Then, this morning, out in the car again.
> Three blocks from the house, the clutch fails.
> The White Post rebuild, fails yet again....
DON JULIO 1942