Just measured what I believe to be an original pump and it is 4 7/8 from
back of pump to outer face of pulley flange.
Bob H
----- Original Message -----
From: "Ronak, TP (Timothy)" <Timothy.Ronak@crna.akzonobel.com>
To: <tigers@autox.team.net>
Sent: Tuesday, March 18, 2008 8:26 PM
Subject: [Tigers] Water pump flange height
> Listers,
>
> Can anyone confirm the stock pulley flange distance for a 260 Tiger.
> Based on my research it should be 4.875 inches from the back of the pump
> bolt on flange to the outer face of the pulley flange. I realize this is
> different than the shop manual. I am going to go press two pumps but do
> not have a pump to go off of that is off of the car. (never thought to
> save one) if anyone can confirm this before I go jack up two Edelbrock
> pumps I would be VERY grateful.
>
>
>
> Best Regards,
>
> Tim Ronak
> Services Consultant
>
> Akzo Nobel Coatings
> 23961 Via El Rocio
> Mission Viejo, CA 92691
>
> Bus: 949-305-5393
> Fax: 425-955-6268
> Cell: 949-289-3357
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|