tigers
[Top] [All Lists]

Re: [Tigers] Timing deviates - advice needed

To: rfraser@bluefrog.com
Subject: Re: [Tigers] Timing deviates - advice needed
From: Jay Laifman <jay.laifman@gmail.com>
Date: Sun, 25 Mar 2012 22:01:23 -0700
Cc: 'Gary Pointer' <gpointer@telusplanet.net>, tigers@autox.team.net
Delivered-to: tigers-archive@autox.team.net
Delivered-to: tigers@autox.team.net
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=gmail.com; s=20120113; h=subject:mime-version:content-type:from:in-reply-to:date:cc :content-transfer-encoding:message-id:references:to:x-mailer; bh=+sOYGRLYjxwf0RCvY4Gfugh7EdPXWqJw1uDu9I7RgjQ=; b=Fw7OiAEq9FqOLWNNpb2ytavXRnghXSJWbJK7zMmMsOvjzqMS7lQEc02zKiKoDKzHyi VYCbq/kKZiUkfT9vvZv/3zO7IF/sKP9jAXFO4nXPzFzeBiFl1M5DJ5JOV42ewkBzUZC1 cOXciQPEzGo9lmAC6H9OOxLObeik4SSmEMXl+GTWFssqFS6J+E7d2IlBUx+wJZGBCMFI WDx+Oj03eryOK1I9TGz7s1WVk4jrdtQWP+N/qIvuJVWQjbn26f3T6QbN/twtkReE6Gkr tZv5XNNXDQD4W9D8ImpiE0k/UcnLnayq2XA8S5etwK79HEZFx9S8P+Tnc8zkS80K+JGV wNGw==
List-archive: <http://autox.team.net/pipermail/tigers>
List-help: <mailto:tigers-request@autox.team.net?subject=help>
List-id: Sunbeam Tigers <tigers.autox.team.net>
List-post: <mailto:tigers@autox.team.net>
List-subscribe: <http://autox.team.net/mailman/listinfo/tigers>, <mailto:tigers-request@autox.team.net?subject=subscribe>
List-unsubscribe: <http://autox.team.net/mailman/options/tigers>, <mailto:tigers-request@autox.team.net?subject=unsubscribe>
References: <A6BAB27ACE6145988DA1275FADF6065F@ronpc1>
I'm going to ditto the sentiment that something is loose or cracked because
each time you touch the distributor, you "cure" the problem.   My suggestions
are the cracked cap that someone else already mentioned and the power wire to
the distributor.  The wire could be bad and when you move it, it gets better
contact again, until it wiggles loose again after driving.  Also, on the
distributor, I don't know the Mallory in particular.  But, how does the cap
"seat" on the distributor itself?  Could it be that the tab, or whatever it
uses, is messed up and the cap itself can rotate too much?

Also, a number of people have mentioned the gear at the bottom of the
distributor.  You said it looked fine.  How is the gear held on to the shaft?
Could it be that the pin - or whatever it uses - is broken and the gear can
actually slip on the shaft - but look fine from the outside?
_______________________________________________

tigers@autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: 
http://autox.team.net/mailman/options/tigers/tigers-archive@autox.team.net



<Prev in Thread] Current Thread [Next in Thread>