The Brinkers wrote:
>
> What is the secret? I have replaced my clutch and used the alignment tool.
> Now as I am refitting my Transmission, I can not get it in! I had it
> aligned correctly and cot the two mating surfaces (the bell housing and the
> engine) only 2 inches apart but I could not get them any closer. I have
> raised the motor slightly upward toward the rear to help but still no luck.
> Could someone who has been through this make some suggestions. I would very
> much appreciate it.
>
> Mike - Trying to get on the road again 74 TR6
Mike, having done it twice, the first time it slid right in, the second
time it was like you describe, and I have no easy answer. I remember
playing with the jack holding up the rear of the motor while my wife
pushed, and suddenly it popped in ( the tranny that is).Good luck
Stu
74 TR6 (with heavy overdrive)
|