| To: | Eric Straub <ericst@MICROSOFT.com>, "'Bob Lang'" <LANG@ISIS.MIT.EDU> |
|---|---|
| Subject: | RE: Removing Rear Hubs |
| From: | Gernot Vonhoegen <gernot.vonhoegen@stir.ac.uk> |
| Date: | Sat, 10 Oct 1998 13:01:33 +0100 |
| Cc: | bdstinocher@sewsus.com, triumphs@Autox.Team.Net |
> This is true. However, the original message was about pulling apart an
> outer hub on a TR6 or TR250 - the bolt circle for the TSSC device does
> not have the requesite 4 by 4.5 inch circle holes that you need in order
> to take apart outer TR6 hubs...
>
> > Eric.
SO, can the thing not be modified,i.e. the respective holes drilled?
I've never seen the thing so excuse me for asking but would certainly save a
lot of trouble if one could mod that puller.
Gernot
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: OD - first use questions, KTRIUMPH |
|---|---|
| Next by Date: | Re: Rimmer Engines, Herald948 |
| Previous by Thread: | RE: Removing Rear Hubs, Peter Zaborski |
| Next by Thread: | Re: Removing Rear Hubs, ralph.jannelli |
| Indexes: | [Date] [Thread] [Top] [All Lists] |