In a message dated 2/7/99 11:37:26 AM EST, brad.kahler@141.com writes:
<< I've removed the axle shafts from my TR4 and I've been trying to press off
the rear hub using my hydraulic press. I've got the hub supported real well
and I put a small socket on top of the shaft where the press would contact
the threaded end of the shaft. My press only has a 12 ton jack on it and so
far I haven't been able to break the axle free. My question is would a
little
heat from a torch at the same time help pop it free? Any other suggestions
would also be greatly appreciated. >>
You need a special tool for this. I have seen hubs bend before they come off.
If absolutely neccessary to remove the hubs I would check out finding someone
who has one of these tools and have them do it. I am pretty sure TRF has them
and I think they are still available for sale outright. They cost about $400,
but I understand they work great. There's a picture of this thing in the
workshop manual.
Ken Nuelle
58 TR3A
62 TR3B
64 TR4
|