| To: | "triumphs mail list" <triumphs@autox.team.net> |
|---|---|
| Subject: | Model 10 trivia |
| From: | kengano@advant.com (Gano, Ken) |
| Date: | Sun, 16 May 1999 00:08:34 -0500charset="iso-8859-1" |
| Importance: | Normal |
One of those useless facts. The upper shift lever seal on a Model 10 transmission linkage is the same inside and outside diameter as the master cylinder dust boot off a TR3. You only need to cut around the outer most diameter to make it one ply rather than two (two fits, but the seal is then to fat for the securing cap to lock down.) Ask me know I know. Ken Gano With a smooth shifting Model 10 and part of a TR3 master cylinder rebuild kit! |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: TR4 won't start, DANMAS |
|---|---|
| Next by Date: | TR6 clutch question, richard bacon |
| Previous by Thread: | GT6 rearend swap, Blofed |
| Next by Thread: | TR6 clutch question, richard bacon |
| Indexes: | [Date] [Thread] [Top] [All Lists] |