In a message dated 00-04-10 19:40:36 EDT, VK0216@aol.com writes:
<< Also, what holds that little piece to the frame. Is it
meant to slip onto either end of the larger chrome.
thanks......Virgil 75 TR6 >>
Here's an idea - not the most period correct but might save you from
replacing the "chrome" molding entirely......use both connector pieces - they
slip over the windshield trim - if you can find a piece of scrap molding, cut
a small piece and place it dead center in the 3" gap so it leaves about a
1/2" gap on each side....then fit the 2 connector pieces over the 2 gaps
centered side-by-side (I use silicon seal to adhere)....then take a picture
of it and share it with us so we can see what it looks like....
'76 TR6 CF57822U (restoration underway)
'70 Spit Mk3 FDU78512L (ready for another driving season)