In a message dated 9/23/00 11:53:14 PM Eastern Daylight Time,
<< Would someone please wave their magic wand and tell me the easy way to get
those two darn bolts out holding the Rad it's self in place on a TR3.
I have the "Skid" pan out, but can not fit a wrench in there other than a
1/16 of an inch movement at a time if I'm lucky.
I can get a socket in there but not the ratchet extention due to the lower
frame lip, nor does a Universal fit.
I've done this many times using a 3/8" drive ratchet & U-joint. It is tight
tho'. Not sure offhand of any other way to do this.