Plug welding - thanks

[Cliff Hansen <hansenc@flash.net>]

Thanks for the advice.  Universally:

- use a largish hole (at least 1/4")
- use higher heat and slower wire speed
- start from the middle (the non-holed panel) and work out

I'll get to try this out after the holiday parties at work are over
(tomorrow night.)
Oh and rule number 4: don't let the wife watch the electric meter while
you're welding.  Something about that National Lampoon Griswold movie...


Cliff Hansen
hansenc@flash.net
1966 TR-4A CTC 64615L (in about a thousand pieces)