Hello Fellow listers,
I am in the process of putting my TR3 engine back together. My
question is what jointing compound have people used with succes
with the felt rear bearing cap seal. This is the seal where the
Haynes manual describes installation "Soak the crankshaft rear
main bearing cap sealing felt in liquid jointing compound and
carefully slide the felt down the channel as shown in the photo.
When it is in the fully down position trim the end with a sharp knife..
The jointing compounds that I have seen are like paste rather than
57 TR3 TS21383L "Bettie"
Natick, Massachusetts USA
/// firstname.lastname@example.org mailing list
/// To unsubscribe send a plain text message to email@example.com
/// with nothing in it but
/// unsubscribe triumphs