At 02:13 PM 1/11/04 +1100, Trevor Jordan wrote:
>Some questions and a few observations that might be of interest to the list.
>
>
>[The clutch specialists made an interesting observation about the weight
>of the TR6 clutch. The wear on the diaphragm was about 10 mm from the
>ends of the fingers. They believe that the clutch was designed for a
>smaller diameter TOB that would press closer to ends of the fingers. This
>would reduce the actuating force. However, the size of the gearbox input
>shaft precludes the use of a smaller TOB.]
I'd check to see if the previous clutch installer put a TR3-4 throwout
bearing in instead of the TR6 t/o. The earlier t/o bearing has a flat face,
but the TR6 one has a curved face.
uncle jack
|