Re: TR3A bleeding procedures i14GH08A007560

[reveye@speakeasy.net]

Tom,  I didn't bench bleed them first.  I figured I could bleed them at the 
input line at the master cylinder once it was on the car, because I have no way 
of suppling fluid to the master without the line being hooked up, unlike all 
the  Domestic master cylinders which have their reservoirs built-in.  Am I 
correct on this?

Jim


> Jim, did you bench bleed the master cylinders before you installed
> them.  
> -- 
>       Best Regards,
>       Tom