The following is something I saved from 1999, I've never done it but here it
is for your enjoyment and with proper acknowledgements
Tom
----- Original Message -----
From: "Kramer" <kramer@subzero.iceinet.com>
To: "Kramer, Cosmo" <triumphs@autox.team.net>
Sent: Sunday, December 12, 1999 10:27 AM
Subject: Badge Bar
>
> Ok Cosmo, You've peaked my interest. How did you do it. -Brian Sanborn
> -----Original Message-----
> From: owner-triumphs@autox.team.net
> [mailto:owner-triumphs@autox.team.net]On Behalf Of Kramer
> Sent: Saturday, December 11, 1999 2:31 PM
> To: Kramer, Cosmo
> Subject: Badge Bar
>
> Hi List!
> I own a TR4/A & I made my badge bar for about $15.00 two years
> ago.
> It's very simple. If you own a TR4 then it will cost you for just the
> bar, which is even easier & cheaper. If any of you are interested then
> E-mail me of the list. -Cosmo Kramer
> --------------------------------------
> Hi Brian & List!
> You own a TR4, yes? Pick-up a bar that you want to use as you "Badge
> Bar". I went to one of my machinest friends & asked what he had in
> Stainless Steel. The go to your local bicyle shop & purchast two Rear
> stay mounting clamps for non-braze on luggue racks. Put the clamp around
> the overriders upper suport bar. Put your machine bolt through the hole
> in the clamp, then the rubber cork, star washer, & nut. Put all this
> inside the opening of the bar & tighten the screw. Now you are ready to
> mount your badges or lights on it. If you have any question, PLEASE feel
> free to ask. I own a TR4/A & had to use angles iron for mounting the bar
> to it. I also milled out slots so I can rise or raze the bar as I wish.
> -Cosmo Kramer
|