I am just getting started rewiring my TR3 with a Dan Master's kit. I
have completed the rear lighting system & the gas tank float. I am
now beginning the instrument panel. There are a number of switches
that have hole in which you insert the wire and then clamp it in
place with the end of a machine screw. My question is should one
solder the end of the wire before clamping it or leave it unsoldered??
Thanks
John
John A. Wise
Glendale, AZ
1960 Triumph TR3A
Commission No: TS80422L
http://members.cox.net/60tr3a/
http://www.triumphowners.com/876
1977 Porsche 911S
http://members.cox.net/porsche911s/
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|