Brian, I had the same problem. Upon the suggestion of some other TR guys
here in PA, I now use a T-handle MGB, 70-74, choke handle setup on my 4A. I
believe it works and locks really well IMHO. HTH, Ted
T-handle MGB, 70-74 choke handle setup
http://www.zeni.net/trf/MGB-GC/index.php?menu=C&page=42
vs. traditional TR250/TR6 choke setup
http://www.zeni.net/trf/TR6-250GC/39.php
or the TR4 choke setup
http://www.zeni.net/trf/miniTR4/11.php
On Jan 24, 2008 11:21 AM, Randall <tr3driver@ca.rr.com> wrote:
> > Is there a source for a TR4-correct choke cable that reliably locks?
>
> I bought an aftermarket TR3 cable from Moss almost 20 years ago, and it
> still works. Had a fixed knob that didn't exactly match the original, but
> after rounding the corners a bit with sandpaper, it looks at home. And
> the
> twist-lock works quite well.
>
> > Or can the locking mechanism on an old cable be 'refreshed'.
>
> Depends on what is wrong with it. I've fixed at least one cable that I
> think might be original to a Triumph, by fabricating a replacement for the
> part that locks to the shaft. It was just a "D" shaped piece of flat
> brass
> and the original one was worn out. The shaft was also worn, so I made the
> new piece a bit oversize to compensate.
>
> Randall
>
--
T.L.L.
1966 TR4A CTC 73139 LO
http://www.triumphowners.com/967
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|