On Tuesday 11 March 2008 04:34 pm, Tom Wagner wrote:
> To All:
>
> Can someone let me know where to start looking for a piston sticking
> on HS4 carbs. I have checked the oil level in the dashpot and also
> cleaned the inside of the chamber, along with the needle on the end of
> the piston. This is on a 67 MGB, but I know there are some out there
> that have MG's that might be able to help me out.
>
> All help would be appreciated, and Thanks in advance
>
>
> --
> Tom Wagner
> 72 TR 6
> 67 MGB
> Gravette, AR 72736
Tom,
Most likely problem is the needle is not centered.
Next could be the Damper. Could be bent.
One other think I have seen is the piston part that enters the top assembly is
bent. Only fix here is to replace the whole piston.
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|