In difficult spaces to hold the weather-stripping to a tighter bond, I have
used contact cement on the seal side as well as the contact side of the panel,
then before I make contact to weather strip I heat the strip with a hair dyer
to speed up the tackiness. It helps in those difficult tight areas. I use
lacquer thinner for clean-up.
Ibsen
----- Original Message -----
From: Geo & Kathleen Hahn
To: L1J1S@aol.com ; triumphs@autox.team.net
Sent: Friday, March 21, 2008 5:22 PM
Subject: Re: [TR] rubber adhesive
The 3M adhesive or just plain old weatherstrip seal usually works but I have
encountered some seals that won't stay put w/o something much stronger (the
TR4 boot seal comes to mind). For that I used Gorilla Glue (or the Elmers
equivalent).
Geo
----- Original Message -----
From: <L1J1S@aol.com>
To: <triumphs@autox.team.net>
Sent: Friday, March 21, 2008 2:09 PM
Subject: [TR] rubber adhesive
> hello, i would like to know what u guys rec' to use when i put on
> the"rubber" to the body of my car. for example, tire trunk seal. door
> seals, etc. larry
> schwartz 1960 tr3-a
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as flashtr3@cox.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|