triumphs
[Top] [All Lists]

Re: [TR] TR3A Assembly

To: <DLylis@aol.com>
Subject: Re: [TR] TR3A Assembly
From: "Alex" <ambritts@bellsouth.net>
Date: Mon, 15 Sep 2008 07:40:54 -0400
Hi Dave,



>A couple of questions:
> 1.  Is the rubber boot seal glued into place?  Mine won't stay on  as I
> expected it to.  If so, what adhesive?

Mine is glued in place. I placed the joint at the bottom.
3M Super Weatherstrip Adhesive #B1731-80

> 2.  Same question for the spare cover seal.

3M Super Weatherstrip Adhesive #B1731-80

> 3.  What material is recommended as a seal between the inner and outer 
> front
> wings?

3m Strip Caulk #051135-08578    20 yds in 1' x 1/4" lengths I used 2 
parallel strips/fender.

> 4.  Is this to be used between the inner and outer rear wings as  well?

I did not use it there, but your option. Easy to work with.

> 5.  The rubber gas cap seal provided was a grooved arrangement that 
> slipped
> over the edge of the body panel hole.  Unfortunately, the threaded  male 
> part
> of the chrome cap would not fit through the remaining hole to thread  into 
> the
> brass under panel piece.  I assembled without for the time  being. The 
> part
> ordered appeared to be correct for my car.  Do I  have the incorrect gas 
> cap
> assembly?  I don't care to change the  gas cap, just provide a rubber 
> seal.

Not sure on this one. I did have a problem getting it to seat correctly. Had 
to shorten the  rubber hose length between the tank and the cap. It was a 
little tricky because you don't want to cut it too short for obvious 
reasons.


> Does anyone have a "known to work" technique for covering the dogleg cap
> just behind the doors?  The supplied kit has leather provided.  I 
> originally
> covered mine with vinyl using 3M spray trim adhesive and was quite  happy 
> with
> the results until the car sat in the sun and the adhesive let go at  the 
> stress
> points.  This is a do over.

I don't remember who supplied me with a picture of the form cut out of 1x4. 
It is mounted in a vise and holds the dog leg so you have use of both hands. 
I soaked my leather over night in water. Use the same 3M Super Adesive 
above. I started at the sharpest curve at the bottom and worked out in both 
directions. Make sure to allow the ahesive to flash off before applying. 
Makes for a much better job. Don't pull to hard and over stretch the 
leather. I have had no problems in Florida heat. I might have a picture of 
it or maybe even have the wooden form. Let me know if no one adds in and I 
will look for both.
Alex Manzo
72 TR6
59 TR3A
>
> TIA
>
> David  Lylis
> 69 TR6 CC26160L
> 60 TR3A TS74461LO
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>