I'm not into re-building my tr-3 engine yet but have some questions concerning
liner protrusion, blowing head gaskets ect. Several members have mentioned
that the protrusion is higher on one side of the block than the other. How do
you handle this? You can't add 1/2 of a figure of 8 gasket to one side to (in
effect) tilt the liner making the protrusion equal on top. so do you then
just add gaskets to get a happy medium?
thanks
gary n.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|