triumphs
[Top] [All Lists]

Re: [TR] TR3A Rear Brake Drum

To: "Scott Suhring" <suhringtr36@comcast.net>, "Triumph Mail List"
Subject: Re: [TR] TR3A Rear Brake Drum
From: "dorpaul" <dorpaul@bellsouth.net>
Date: Mon, 13 Apr 2009 22:41:30 -0400
Scott,
I've heard this tightness will settle in, maybe?
Paul

----- Original Message ----- 
From: "Scott Suhring" <suhringtr36@comcast.net>
To: "Triumph Mail List" <triumphs@autox.team.net>
Sent: Sunday, April 12, 2009 10:34 PM
Subject: [TR] TR3A Rear Brake Drum


> Well, I got the new rear cylinder installed in my '59 TR3, but have
> encountered a problem that I am scratching my head over. Before I needed 
> to
> replace the right rear brake cylinder, my wheel/brake drum turned freely.
> Now since I replaced the cylinder, I can barely get the drum on and once 
> on,
> you cannot spin the shaft due to the shoes being so tight on the drum. I
> have changed nothing else, measured the piston against the old cylinder, 
> and
> although the pistons have a different shape, the measurements seem to be 
> the
> same. The adjuster wedges are also fully in. Any thoughts as to what could
> be causing this problem? I can try installing the old cylinder after
> rebuilding it or I could have the drum shaved down a bit.  TIA
>
> Scott Suhring
> Mechanicsburg, PA
> '70 TR6
> '59 TR3
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as dorpaul@bellsouth.net
>
> http://www.team.net/archive 
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>