triumphs
[Top] [All Lists]

Re: [TR] TR3 liners

To: Jim Bauder <jimbpps@cox.net>
Subject: Re: [TR] TR3 liners
From: David Lylis <dlylis@gmail.com>
Date: Sat, 20 Jun 2009 16:08:56 -0400
Removing the motor is much easier than anything your have described so far.

On Sat, Jun 20, 2009 at 3:56 PM, Jim Bauder <jimbpps@cox.net> wrote:

> Kevin,
>
> I definitely would recommend removing the engine from the car!
>
> The reason you can't get the liners out is rust and crud from close to 50
> years
> of DPO neglect. At least that was the case with my '58 TR3 that I restored,
> there was so much crud behind the liner of cylinder #4 that it was all I
> could
> do to drive the liner out when the engine was upside down on the floor! I
> had it
> on the garage floor with some large blocks of wood to raise the block up
> for
> clearance and used a 2 X 4 to drive them out, it was not easy. You will
> also
> need to have the block 'hot-tanked' to get rid of all the deposits, and
> crud
> that you won't be able to scrape out.
>
> Trust me, you will get a better job on the rebuild with the block out of
> the
> car!!
>
> Regards and good luck,
>
> Jim
> Jim Bauder
> 480-309-9525
> '68 TR250 CD47L
> Scottsdale, AZ
> http://www.triumphowners.com/647
>
> -----Original Message-----
> From: triumphs-bounces@autox.team.net [mailto:
> triumphs-bounces@autox.team.net]
> On Behalf Of KEVIN KEALTY
> Sent: Saturday, June 20, 2009 11:48 AM
> To: triumphs@autox.team.net
> Subject: [TR] TR3 liners
>
> Hi all.
>
> I am having no luck removing the cylinder liners from the block.  Between
> using
> an air-hammer and a hammer and chisel I have managed to get one liner up
> about
> 1/2 inch above the surface of the block.  I thought it would get easier,
> but it
> hasn't.  The front of the car is on stands, so I can't get that good a
> hammer-swing from the bottom.  I am thinking of having someone weld an old
> bolt
> or scrap of metal to the top of the liner and use that to try to pull it
> out.  I
> REALLY don't want to remove the engine.
>
> Any ideas?
> Thanks,
>
> Kevin
> '62 TR3B
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as jimbpps@cox.net
>
> http://www.team.net/archive
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as dlylis@gmail.com
>
> http://www.team.net/archive
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>