firstname.lastname@example.org wrote :
> I would not go near a piece of plexi with a heat gun unless I was
> trying to form it.
Since you've raised the topic, what is the easiest way for a total novice to
go about putting some mild bends in some 3/16" Plexiglas? I've got some old
AMCO wind deflectors for my project TR3, but the plexi is broken on one
side. The original had a gentle S-curve to fit around the car body better,
which I would like to duplicate for a replacement piece.
Is a heat gun the way to go? Are we talking hair dryer or heat shrink
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register