triumphs
[Top] [All Lists]

[TR] it has been a long week

To: Triumph List <triumphs@autox.team.net>
Subject: [TR] it has been a long week
From: "Jim Muller" <jimmuller@rcn.com>
Date: Thu, 23 Jul 2009 22:20:15 -0400
Way too long, and no real progress.

Last time I test-drove the GT6 it still wasn't happy.  I drove for 
just two blocks and it became obvious that Spock isn't firing on all 
thrusters.  So far I've replaced plugs, dizzy cap and rotor, 
condensor, plug and coil wires.  And the coil (Lucas Sport, DIR105, I 
think it said) measured about 1 Ohm between + and - terminals.  I 
read 0 Ohms between the points-mounting plate and ground, as 
expected.  When I pulled the plugs the front three were sooty, the 
back three relatively clean.  That suggests a bad front carb, though 
poor firing would make them black anyway.  They are SUs, no diaphrams 
to break, and the plungers move easily.  The needle looks good, the 
jet moves properly with the choke cable and returns as it should.  
The float level is good and the needle valve isn't stuck.  Maybe one 
of the throttle positioning clamps on the shaft slipped so the carbs 
aren't synched very well, but they aren't moveable by hand and look 
about right.  In any case, a quick check with a synchro tool will 
show a problem with that.  I may swap the coil for the one in the 
Spitfire, or just spring the $30 for a new one, but it doesn't seem a 
likely problem.  Beyond that, I'm stumped.

Which is another way of saying I'm stumped.

I haven't had time to check performance since putting in the new 
plugs.  It's been a long week.  When the dust clears I'll check it 
out again.  Maybe the plugs will make it all better.  But I doubt it.

Which is another way of saying I'm stumped.

Jim Muller
jimmuller@rcn.com
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>