Unfortunately not. Someone on the internet shows how he welded 'repair panels'
cut from a TR6's lower front front fenders rear areas to graft to his TR4
fenders but the TR6 lengths in that same area was 2" shorter so he had to
make up the difference with additional sheet metal to reach the door. The
wheel wells are longer on the TR6. But he made it work - just a little more
work than he didn't know would be required.
Carl
Do others agree with me that the major difference between a 4's fender and a
6's is the front and that the bottom part below the suage (fold above the
wheel arch) is the same.
Jim and the TR4
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|