triumphs
[Top] [All Lists]

Re: [TR] valve adjuatment problem

To: npaul72464@aol.com,wayne@motorcarriage.com,yellowtr@adelphia.net,
Subject: Re: [TR] valve adjuatment problem
From: Tony Drews <tony@tonydrews.com>
Date: Sat, 03 Apr 2010 15:50:15 -0500
I'm sorry to say that I can't think of any scenario that would cause 
that problem that doesn't involve pulling at least the head.  It 
sounds to me like either something is wrong with the cam / tappet or 
the valve is recessing deeply in to the head or the head of the valve 
is ready to come off.  The straightedge across the valves seems to 
largely rule out the last two scenarios.  Best case is that something 
fell into the tappet, the pushrod is sitting on top of it, and it can 
easily be removed without further disassembly.

- Tony Drews

At 12:37 PM 4/3/2010, npaul72464@aol.com wrote:
>  Hi All,
>
>I'm in the midst of adjusting the valves on my 1958 TR3A and have run into a
>snag.  They all adjusted fine till I got to #8 where there is no gap and no
>turning of the screw will give me any.  I checked compression (for some
>reason) and there's 150 PSI in all 4 cylinders.  I pulled the rocker shaft and
>the rocker and push rod look normal compared with all the others.  I put a
>straight edge across all the valve springs and they're all the same height.
>
>Any insights would be much appreciated.
>
>Ned Paulsen
>Webster, NY

_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>