I have replaced all of my lamps with the Litezupp LED lights and am very
please with the results. I did convert to the new flasher from NAPA that is
mentioned in the Litesupp website. I did have a problem though. When tuning
on the ignition and testing all worked well. When the engine was running the
turn signals worked very poorly if at all. By feeling the flasher when the
engine was running I would detect that the contacts were trying to pickup but
were not fully closing. I was running non resistor plug wire and non resistor
plugs and found that by replacing my plugs with a resistor type plug it took
care of the interference that was causing the flasher units to not work
properly.
Rod Trunnell
TR3B TCF1037l
________________________________
From:
Brian Jones <Brian.L.Jones@gsk.com>
To: "triumphs@autox.team.net"
<triumphs@autox.team.net>; "anabil007@comcast.net" <anabil007@comcast.net>
Sent: Tue, May 25, 2010 6:57:32 AM
Subject: [TR] LEDs and Flasher
Bill,
I
only use Litezupp as tail & brake lamps.
If you want to replace your turn
signals too, they provide the following
directions on their website:
http://litezupp.com/content/flasher-conversion-instructions.
Brian
.net
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|