triumphs
[Top] [All Lists]

Re: [TR] 3rd gear snapring

To: mlang99@comcast.net
Subject: Re: [TR] 3rd gear snapring
From: TRDOCTOR@aol.com
Date: Sun, 12 Jun 2011 23:34:36 EDT
I purchased one of the last Churchill tools from TRF a few years ago along  
with the installation tools.  Mine does not have a threaded rod.  It  is 
knurled on the outside of the tool. Sure makes the job easier!!
Sam
 
 
In a message dated 6/12/2011 10:12:39 P.M. Central Daylight Time,  
mlang99@comcast.net writes:

I have  now used it to remove the snap rings from a couple of
transmissions. It  works really slick. Way better than trying to
manipulate 3 or 4 screw  drivers at the same time.

The snap ring tool that I've got has a  threaded rod in the end of it
that acts as a  puller.

Thanks,

Mike

TRDOCTOR@aol.com wrote:
>  Smack it with a hammer and then use a screw driver to work it up onto  
the  
> tool.  You will probably have to chuck the tool in a  vice to pull it off 
of  
> the shaft with the snap ring on the  tool.  You won't hurt the tool.  I  
> have done it  several times.
>  
> Sam Clark
> Green Country  Triumphs
>  
> So what's the trick to removal of the 3rd gear  snap ring off of the  main
> shaft? I have always used multiple  screwdrivers in the past but I
> now  have the Churchill tool for  doing it. Smack it with a hammer and
> drive it  under the snap  ring? Put it in a press and push it under? I've
> never used one   before and don't want to break anything in the process
> (especially the  tool  :-).
>
> Mike
>  TS11544L
triumphs@autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>