1961 TR3A
What is the correct placement of the wiper & panel switches?
TRA guidelines have Wiper/Panel (Top/middle); changed at TR3 to Panel/Wiper
ISTR recall that it was later switched again to accommodate the rheostat
Panel. Searched the archives but the emails I found were unclear as what
was correct when
I have a two-speed wiper switch that if placed in the top hole, the word
wiper does not align correctly (off cw 45d). Panel rheostat is a tight fit
in top hole. (FYI both holes are =)
Alternatives:
1) I can mount Panel rheostat in top hole and the wiper switch can be
installed in the middle hole so that the switch is aligned correctly.
2) Mount Panel Switch in middle; Wiper on top and have a knob engraved
with proper alignment.
And the collective wisdom of the list is?
Thanks
Carl
|