In a message dated 4/3/2012 3:47:34 PM Central Daylight Time,
agraham at execulink.com writes:
> Trying to figure out the seal orientation on the spare tire compartment
> lid. I did check the archives (thanks Mark!) and sorry to say I am still
> confused after reading the few messages on this topic.
> I think I have it figured, but before I slather everything up with
> weatherstrip sea, just wanted to verify the seal orientation.
> I take it that the seal 'extension', the short flap that extends out
> from the seal body, is oriented towards the spare tire opening, slightly
> covering the sharp edge around the opening. It does not orient towards
> the body.
>
Good question. we were looking at this the other day and came to the
opposite conclusion - that the lip extended out to separate the cover from the
body.
I'm sure TRA has an opinion on this.
Dave
|