triumphs
[Top] [All Lists]

Re: [TR] TR6 carb neadles

To: yellowtr3@yahoo.com, triumphs@autox.team.net
Subject: Re: [TR] TR6 carb neadles
From: Dave1massey@cs.com
Date: Mon, 11 Mar 2013 13:34:10 -0400 (EDT)
Delivered-to: mharc@autox.team.net
Delivered-to: triumphs@autox.team.net
Full-name: Dave1massey
The rebuild kits are generic but the needles are specific to the model, 
market and year of the car so other than including all possible needle 
selections the only option is to supply none.  (Makes for a less expensive kit) 
 

Yes, the needle is spring loaded.  This eliminates the need to center the 
jet (which you can't do on a ZS carb anyway).  To remove you remove the grub 
screw on the side of the piston and then back off the adjustment and the 
needle assembly will withdraw from the bottom of the piston.

The jets themselves are pressed in.  I've never changed one so I don't know 
the best way to go about this.  Pressing one in means you have to set the 
proper depth so be sure to measure the depth before you remove the old one.

Dave (I've got a couple of kits coming in the mail myself)

In a message dated 3/11/2013 11:40:43 AM Central Daylight Time, 
yellowtr3@yahoo.com writes: 
> first frustration is buying a "rebuild kit" that contains
> only 1/2 the parts you need to rebuild! got new jets but no new needle. 
> what
> the heck?
> 
> couple questions:
> 
> first how do you get that jet out?
> 
> second.
> how do you get the needle out?
> and the needle was wobbly. you could push it
> sideways a little. is that normal? yes we had the little grub screw 
> screwed in
> and the little brass collar turned so the slot lined up with the grub 
> screw..
> 
> also we could pull the needle down and it would pop back in like its on a
> spring. is that normal?

** triumphs@autox.team.net **

Archive: http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>