- 1. [Mg-t] gas tank coating (score: 1)
- Author: dhhall@bellsouth.net
- Date: Sat, 28 Jun 2008 17:03:07 +0000
- I would like to coat the inside of my MGTD gas tank with a protective coating (Red-Kote). The tank seems to be segmented inside. I'm not sure if I need to unscrew the plate on the lower back side to
- /html/mg-t/2008-06/msg00035.html (7,061 bytes)
- 2. Re: [Mg-t] gas tank coating (score: 1)
- Author: Mike Duvall <duvallcom@sbcglobal.net>
- Date: Sat, 28 Jun 2008 12:10:16 -0500
- It is all welded together and you cannot take it apart...The sender is the small plate on the back and it won't do any good to remove it other than protect it from the coating (if you need to) You ei
- /html/mg-t/2008-06/msg00036.html (7,963 bytes)
- 3. Re: [Mg-t] gas tank coating (score: 1)
- Author: Bud Krueger <budkrueger@comcast.net>
- Date: Sat, 28 Jun 2008 16:31:40 -0400
- Yes, there are baffles welded in place inside of the tank. Yes, you should remove the petrol level switch float. Otherwise the coating will total mess it up. If you insist upon coating the tank be ce
- /html/mg-t/2008-06/msg00039.html (7,411 bytes)
- 4. Re: [Mg-t] gas tank coating (score: 1)
- Author: John Seim <kingseim@earthlink.net>
- Date: Sun, 29 Jun 2008 06:36:35 -0700
- That is the sending unit for the low fuel warning lamp. It does not work if coated with something else. If it has been in since car was new, then probably need a new one. So, go ahead, and slosh the
- /html/mg-t/2008-06/msg00043.html (8,686 bytes)
This search system is powered by
Namazu