- 1. TR engine rebuild (score: 1)
- Author: Unknown
- Date: Thu, 22 Oct 98 11:09:46 CDT
- Well, got the bad news from the machine shop. The sleeves will have to be bored (to 87mm), and the crank .10 over. So, ordered pistons/rings, bearings (cam, rod, mains), and thrust washers, gaskets,
- /html/triumphs/1998-10/msg01652.html (6,741 bytes)
- 2. Re: TR engine rebuild (score: 1)
- Author: Unknown
- Date: Sun, 25 Oct 1998 10:18:08 -0500 (EST)
- I sprayed a little Permatex non-hardening sealant on the figure-8 gaskets before I put it all together. I found that trying to tap the sleeves down didn't really seat them (and I was tapping pretty h
- /html/triumphs/1998-10/msg01751.html (7,704 bytes)
This search system is powered by
Namazu