Search String: Display: Description: Sort:

Results:

References: [ +from:wwwdg@webtv.net: 137 ]

Total 137 documents matching your query.

1. Re: Valve Covers on eBay (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Sat, 12 Nov 2005 08:15:05 -0800
Tony, The originals have [BUDDY BAR CASTING] cast inside. Also they have clips for the spark plug wire separators riveted on the top, and oil deflectors riveted on the inside, of course these can be
/html/tigers/2005-11/msg00138.html (6,655 bytes)

2. Buddy Bar Valve Covers (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Sat, 12 Nov 2005 17:25:27 -0800
Here are some photo links to an original "Buddy Bar" Tiger valve cover. On my set only the left side (oil cap side) is marked BUDDY BAR CASTING. The right side looks like the mould might have been re
/html/tigers/2005-11/msg00141.html (7,650 bytes)

3. Re: Horns (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Thu, 17 Nov 2005 08:53:06 -0800
Hi Jim & Jeff, Don't know why they show different horns for the Tiger & Alpine. Could be the Tiger engine & exhaust was louder so they had a louder horn? Probably not. Rootes does show different horn
/html/tigers/2005-11/msg00222.html (8,400 bytes)

4. Re: Tiger Tail Stripe (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Thu, 17 Nov 2005 16:55:39 -0800
Here are some photos from an original (I believe it is original) "Tiger Tail" stripe kit instruction sheet. Note the car shown is an Alpine, also it has the "hard to find" reverse lamps showing in th
/html/tigers/2005-11/msg00247.html (8,207 bytes)

5. Re:ebay car # 7997391450 w/ floor hole (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Wed, 7 Sep 2005 18:14:36 -0700
Got my curiosity up so I checked B382000447, no hole as shown in the eBay photo link below. Someone did add a hole for the transmission filler in B382000447. The hole in the eBay photo is in the wron
/html/tigers/2005-09/msg00091.html (7,098 bytes)

6. Re: Black Holes etc. (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Thu, 8 Sep 2005 19:15:40 -0700
The spark plug hole is there. David Franchi Photo Link http://i7.ebayimg.com/04/i/04/d5/66/76_3.JPG
/html/tigers/2005-09/msg00114.html (6,431 bytes)

7. Re: Heater Valves (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Tue, 17 May 2005 16:53:57 -0700
The correct Tiger valves. Early Tiger heater valve with mounting bracket. http://pic12.picturetrail.com/VOL439/2051017/4748999/94487924.jpg . Later Tiger heater valve without mounting bracket. http:/
/html/tigers/2005-05/msg00229.html (6,681 bytes)

8. Re: *%#! Dip Stick (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Wed, 18 May 2005 08:59:34 -0700
Sorry to take so long to respond to the dip stick question, took a little time to "dig out" my info. . Everything (almost) you want to know about dip sticks. David Franchi . As stated in previous pos
/html/tigers/2005-05/msg00236.html (11,014 bytes)

9. Re: *%#! Dip Stick (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Wed, 18 May 2005 10:58:11 -0700
Is your chrome dip stick the long finger pull? I would think it is, as Chrysler/Rootes probably didn't have the special MII short finger pull stick. The LAT kit probably used a Shelby or later Ford s
/html/tigers/2005-05/msg00243.html (7,486 bytes)

10. Re: hot water contro valve (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Wed, 18 May 2005 15:10:14 -0700
The Smiths part number for the late valve is FHW 1306. David Franchi
/html/tigers/2005-05/msg00246.html (6,275 bytes)

11. Re: *%#! Dip Stick (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Wed, 18 May 2005 17:14:56 -0700
By the posts, It seems that the little bell/dust cap was probably on the short dip sticks and wore out the slot enough to slip by the two retaining "wings" above the bell/cap. It would take an awful
/html/tigers/2005-05/msg00248.html (8,249 bytes)

12. Re: dip sticks / caps (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Fri, 20 May 2005 15:21:16 -0700
http://pic12.picturetrail.com/VOL439/2051017/4748999/95330855.jpg Jim, take a look at the photo link above. The "cap" is captured between the lower flared stick section and the upper two "wings". Eit
/html/tigers/2005-05/msg00267.html (7,154 bytes)

13. Re: Non-Tiger Battery Question (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Tue, 31 May 2005 19:01:36 -0700
I drove from L.A. Calif to Oakland Calif (S.F. Bay area) about 400 miles in a 1967 Chevy El Camino with a 327 engine with a bad alternator (I had a new battery). David Franchi
/html/tigers/2005-05/msg00375.html (6,948 bytes)

14. Re: Heater control valve (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Tue, 26 Apr 2005 17:26:32 -0700
Dave, Don't know if anyone sent you a picture of the Tiger heater bracket. Here you go, for cars to about serial B382000000. David Franchi Photo links... http://pic12.picturetrail.com/VOL439/2051017/
/html/tigers/2005-04/msg00223.html (6,639 bytes)

15. Re: Wow, eBay item. (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Wed, 29 Dec 2004 10:51:27 -0800
They probably wanted an original looking "one piece" system, not aftermarket "put together" system or hi-performance system. Most major foreign car parts company's made original replacement systems f
/html/tigers/2004-12/msg00345.html (7,197 bytes)

16. RE: Ford Part Number Request (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Fri, 31 Dec 2004 09:49:12 -0800
Frank, The MKII parts list shows the cap as C4TZ-6766-A (would be the same for the MKI) "C4TZ" would be a truck part number. This is a black painted 900 nipple cap. I have original chrome caps (not f
/html/tigers/2004-12/msg00374.html (7,188 bytes)

17. LAT 42 style fan on eBay 4501587794 (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Thu, 11 Nov 2004 16:39:33 -0800
There is a Tiger LAT 42 style 6 blade fan on eBay. Link is http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=4501587794 David Franchi
/html/tigers/2004-11/msg00088.html (6,402 bytes)

18. Re: Dipstick Problems, Take Two (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Thu, 12 Aug 2004 08:06:11 -0700
The original dip stick & tube measurements are: Stick - 24 7/16" from the tip to the inside top of the "bell" cover/dust guard. Oil "add" mark 1 1/8" from tip, oil "full" mark 2" from tip. -- Tube -
/html/tigers/2004-08/msg00068.html (7,462 bytes)

19. OT eBay pulley (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Wed, 16 Jun 2004 18:14:46 -0700
If anyone is interested there is a two groove water pump pulley for Tigers wanting to use air conditioning or a faster turning water pump/fan. David Franchi http://cgi.ebay.com/ebaymotors/ws/eBayISAP
/html/tigers/2004-06/msg00122.html (6,342 bytes)

20. OT: Volvo/Tiger 5 Blade Fan (score: 1)
Author: wwwdg@webtv.net (David or Gary)
Date: Sun, 20 Jun 2004 17:53:31 -0700
If anyone is interested there is a Volvo/Tiger 5 blade engine fan with the large 1 1/8" center hub hole on eBay. David Franchi LINK http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=24824
/html/tigers/2004-06/msg00128.html (6,430 bytes)


This search system is powered by Namazu