Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\'76\s+Midget\s+\-\s+Brake\s+Master\s+Cylinder\s+Bench\s+Bleeding\?\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\'76\s+Midget\s+\-\s+Brake\s+Master\s+Cylinder\s+Bench\s+Bleeding\?\s*$/: 4 ]

Total 4 documents matching your query.

1. '76 Midget - Brake Master Cylinder Bench Bleeding? (score: 1): Author: cfiddes@direct.ca; Date: Tue, 19 May 1998 15:05:52 +0000; Hi folks. Having just put new seals in my clutch master cylinder, re-installed, bled and bled, and bled until my girlfriend just said "Enough! I'm not pushing this damn pedal one more time.", someone; /html/spridgets/1998-05/msg00294.html (7,838 bytes)
2. Re: '76 Midget - Brake Master Cylinder Bench Bleeding? (score: 1): Author: Ulix Goettsch <ulix@u.washington.edu>; Date: Tue, 19 May 1998 16:15:52 -0700 (PDT); Chris, in bench bleeding, you connect rubber hoses with the right fittings to your MC (where you normally connect the brake lines) and stick the ends into the filler hole of the MC. Then you pump unt; /html/spridgets/1998-05/msg00299.html (8,651 bytes)
3. Re: '76 Midget - Brake Master Cylinder Bench Bleeding? (score: 1): Author: Frank Clarici <spritenut@Exit109.com>; Date: Tue, 19 May 1998 20:36:20 -0400; Chris Bench bleeding requires 2 short brake lines from the master cylinder fittings back into the resevior. Once you make up the lines, fill it with fluid and push the piston in and out (on the bench; /html/spridgets/1998-05/msg00306.html (9,210 bytes)
4. RE: '76 Midget - Brake Master Cylinder Bench Bleeding? (score: 1): Author: Chris Kotting <ckotting@iwaynet.net>; Date: Wed, 20 May 1998 07:17:41 -0400; Don't do it that way if you're using silicone (DOT5 fluid). You'll end up with a master cylinder full of silicone fluid with a lot of "entrained" air, which silicone doesn't release easily. You'll e; /html/spridgets/1998-05/msg00313.html (9,050 bytes)

Current List: 1 - 4
Page: [1]