Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Fot\]\s+Coil\s+recommendation\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Fot\]\s+Coil\s+recommendation\s*$/: 7 ]

Total 7 documents matching your query.

1. [Fot] Coil recommendation (score: 1): Author: jason@multivintage.com; Date: Sat, 13 Aug 2011 19:24:09 +0000; I use the same setup with a 1.5 ohm coil but do use a 1.5 ohm resistor. Works fine. The coil is a red bosch one. Cheers Chris Gesendet mit BlackBerry von Vodafone I have a Pertronix distributor in th; /html/fot/2011-08/msg00078.html (7,920 bytes)
2. Re: [Fot] Coil recommendation (score: 1): Author: Gt6steve@aol.com; Date: Sat, 13 Aug 2011 15:37:45 EDT; you might check in with Jeff Schlemmer at Advanced Distributors. like Sean says, 'he is passionate about distributors'> he will likely recommend a Bosch. send the whole assembly to him and he will se; /html/fot/2011-08/msg00079.html (8,504 bytes)
3. Re: [Fot] Coil recommendation (score: 1): Author: Tony Drews <tony@tonydrews.com>; Date: Sat, 13 Aug 2011 16:25:05 -0500; Hi Chuck, I run a Pertronix brand distributor and have been told that a 0.6 ohm coil is needed with that dist. No ballast needed. It's been working fine for a couple years. I did have a coil fail las; /html/fot/2011-08/msg00080.html (7,750 bytes)
4. Re: [Fot] Coil recommendation (score: 1): Author: "Chuck Arnold and/or Kathleen Kelley" <triosan@gmail.com>; Date: Sat, 13 Aug 2011 21:36:53 -0700; I cannot recommend to use the resistor which does come with the Bosch coil. The resistor gets hot and its value rises from 1.6 to 1.9 Ohms. If so then you have trouble to start the car when it's hot; /html/fot/2011-08/msg00081.html (8,799 bytes)
5. Re: [Fot] Coil recommendation (score: 1): Author: tr4racing@googlemail.com; Date: Sun, 14 Aug 2011 06:52:35 +0000; I have run a similar setup with similar issues. I installed a "ballast bypass" to a switch on the dash. Bypass the ballast to start and then open the circuit to run through the resistor. It was not; /html/fot/2011-08/msg00082.html (9,280 bytes)
6. [Fot] Coil recommendation (score: 1): Author: n197tr4@cs.com; Date: Sun, 14 Aug 2011 06:20:42 -0400 (EDT); Need a tach. -- Chuck Arnold and Kathleen Kelley _______________________________________________ fot@autox.team.net http://www.fot-racing.com Donate: http://www.team.net/donate.html Archive: http://w; /html/fot/2011-08/msg00083.html (10,032 bytes)
7. Re: [Fot] Coil recommendation (score: 1): Author: Duncan Charlton <duncan.charlton54@gmail.com>; Date: Mon, 15 Aug 2011 16:56:21 -0500; These guys wanted way too much for a set of wheels. I ended up with Panasports which cost about $80/wheel less than what they were quoting. Mark Interesting, these guys are just down the street from; /html/fot/2011-08/msg00107.html (12,624 bytes)

Current List: 1 - 7
Page: [1]