- 1. [Fot] TR Brake drums (score: 1)
- Author: Bill Babcock <billb@bnj.com>
- Date: Sun, 19 Dec 2010 12:46:11 -1000
- Tony...try this website www.japanesenostalgiccar.com Racer Bud -- Original Message -- From: "Tony and Annie Garmey" <horizonracing@msn.com> To: <fot@autox.team.net> Sent: Tuesday, December 21, 2010 1
- /html/fot/2010-12/msg00117.html (13,629 bytes)
- 2. Re: [Fot] TR Brake drums (score: 1)
- Author: "RACER BUD" <budscars@comcast.net>
- Date: Mon, 20 Dec 2010 18:45:43 -0800
- Try auto Parts Warehouse $ 48.00 each. http://www.autopartswarehouse.com/details/QQNissanQQ240ZQQCentricQQBrake_Drum QQ19701972QQCE122-dot-42002.html?apwcid=P1135867996W43b3f85c7ab9e&apwidrd23vtY Jim
- /html/fot/2010-12/msg00118.html (8,026 bytes)
- 3. Re: [Fot] TR Brake drums (score: 1)
- Author: John Frymark <jfrymark@aol.com>
- Date: Mon, 20 Dec 2010 21:52:48 -0800
- Careful...those are finned, but I believe that they are cast ferrous...not aluminum, I do not believe that they are available anymore...Check with Dave at TRF...they used to carry them Chip http://ww
- /html/fot/2010-12/msg00119.html (6,442 bytes)
- 4. Re: [Fot] TR Brake drums (score: 1)
- Author: Tony and Annie Garmey <horizonracing@msn.com>
- Date: Tue, 21 Dec 2010 13:33:47 -0800
- Perhaps everyone knows this, but JIC; note that the 240Z drums will not fit on a TR4 without additional machining. The stud holes are the right PCD, but diameter is too small. Plus the lip of the dr
- /html/fot/2010-12/msg00120.html (6,927 bytes)
- 5. Re: [Fot] TR Brake drums (score: 1)
- Author: "RACER BUD" <budscars@comcast.net>
- Date: Tue, 21 Dec 2010 13:45:25 -0800
- _______________________________________________ fot@autox.team.net http://www.fot-racing.com Donate: http://www.team.net/donate.html Archive: http://www.team.net/archive Forums: http://www.team.net/f
- /html/fot/2010-12/msg00121.html (7,966 bytes)
- 6. Re: [Fot] TR Brake drums (score: 1)
- Author: toodamnfunky@comcast.net
- Date: Tue, 21 Dec 2010 21:54:27 +0000 (UTC)
- II just fit a set of these last year luckily managed to get a set or originals from a friends 240z. I had to open up the center pilot hole on a lathe to match the TR6 hub with a little clearance. The
- /html/fot/2010-12/msg00122.html (8,601 bytes)
This search system is powered by
Namazu