Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Healeys\]\s+Assembly\s+order\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Healeys\]\s+Assembly\s+order\s*$/: 6 ]

Total 6 documents matching your query.

1. [Healeys] Assembly order (score: 1): Author: linwood rose <linwoodrose@mac.com>; Date: Wed, 26 Dec 2007 19:28:40 -0500; I have the doors, aluminum sills, and the windshield left to put on the car. Any preferences on order? Does it make any difference if the windshield is before the doors or vice versa? Thanks. Lin 19; /html/healeys/2007-12/msg00484.html (6,832 bytes)
2. Re: [Healeys] Assembly order (score: 1): Author: "Rich C" <richchrysler@quickclic.net>; Date: Thu, 27 Dec 2007 00:02:11 -0500; Install the doors first, get them properly aligned, etc. Then install the alloy trims and the latches and get everything adjusted. Then install and adjust the windscreen while working with the fit an; /html/healeys/2007-12/msg00486.html (8,065 bytes)
3. Re: [Healeys] Assembly order (score: 1): Author: "Ron Fine" <RonFineEsq@earthlink.net>; Date: Thu, 27 Dec 2007 09:18:48 -0800; Don't forget the rubber seal that is between the top front edge of each door and the end of the dash and side panel. It was a real pain to install after my doors were on but they need to be installed; /html/healeys/2007-12/msg00491.html (8,088 bytes)
4. Re: [Healeys] Assembly order (score: 1): Author: linwood rose <linwoodrose@mac.com>; Date: Thu, 27 Dec 2007 12:39:35 -0500; Thanks, Ron! Yes, I am doing that first. Just finished the right hand side. Time for lunch and then on the the LH side. Rich Chrysler's instructions were VERY helpful. Lin ___________________________; /html/healeys/2007-12/msg00492.html (8,550 bytes)
5. Re: [Healeys] Assembly order (score: 1): Author: Daniel and Diane White <dwhite4949@wowway.com>; Date: Thu, 27 Dec 2007 13:08:45 -0500; If I'm following the logic of the assembly order correctly, the doors w/ side screens would go on first with scuttle seals attached (after first trial fitting the scuttle seals between the dash top p; /html/healeys/2007-12/msg00494.html (7,741 bytes)
6. Re: [Healeys] Assembly order (score: 1): Author: George Haywood <haywoodone@hotmail.com>; Date: Fri, 28 Dec 2007 21:24:42 -0500; I don't know if the aluminum finisher set on your car is the same as on my bj8 but in order to insert the second tiny screw on the horizontal finisher (the one that goes into the rocker panel) you m; /html/healeys/2007-12/msg00531.html (9,756 bytes)

Current List: 1 - 6
Page: [1]