- 1. [Healeys] Engine installation (score: 1)
- Author: Weston Keyes <westonkeyes@hotmail.com>
- Date: Sun, 15 Jun 2008 10:15:13 -0400
- Hello Folks, Is it possible to install a BJ8 motor and gearbox/overdrive unit from the bottom of the car. This assuming the manifolds, water pump etc are off the block first. Thanks Wes Keyes York, M
- /html/healeys/2008-06/msg00441.html (7,007 bytes)
- 2. Re: [Healeys] Engine installation (score: 1)
- Author: "62bt7" <62bt7@prodigy.net>
- Date: Sun, 15 Jun 2008 08:00:10 -0700
- YES IT CAN BE DONE, ONLY IF YOU TURN THE CAR UPSIDE DOWN _______________________________________________ Support Team.Net http://www.team.net/donate.html Healeys@autox.team.net http://autox.team.net/
- /html/healeys/2008-06/msg00442.html (8,008 bytes)
- 3. Re: [Healeys] Engine installation (score: 1)
- Author: "Michael Salter" <msalter@precisionsportscar.com>
- Date: Sun, 15 Jun 2008 11:02:47 -0400
- Hi Wes, I would say definitely not. Although the bottom of the block would probably fit between the frame rails the bell housing and back plate are far too wide. Michael Salter --Original Message-- F
- /html/healeys/2008-06/msg00443.html (7,331 bytes)
- 4. Re: [Healeys] Engine installation (score: 1)
- Author: "Healey Bruce" <healeybruce@roadrunner.com>
- Date: Mon, 16 Jun 2008 14:57:41 -0700
- Having only done a BN7, I would venture to say I highly doubt it for several (1) Assuming you have a lift, I could only think you'd need an overhead crane to lift the engine and tranny up. (2) The ta
- /html/healeys/2008-06/msg00479.html (9,006 bytes)
This search system is powered by
Namazu