Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Spridgets\]\s+universal\s+joint\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Spridgets\]\s+universal\s+joint\s*$/: 4 ]

Total 4 documents matching your query.

1. [Spridgets] universal joint (score: 1): Author: Andy Webster <a_d_webster@yahoo.com.au>; Date: Mon, 24 Sep 2007 18:06:39 +1000 (EST); Anyone have some tips on removing the (front) uni joint from the prop shaft? It isn't keen on moving and it needs to make way for the new front yoke. Can I place a drift against the ends of the bear; /html/spridgets/2007-09/msg00597.html (7,464 bytes)
2. Re: [Spridgets] universal joint (score: 1): Author: "de Brebisson, Cyrille (Calculator Division)" <cyrille@hp.com>; Date: Mon, 24 Sep 2007 13:00:23 +0000; I ended up drilling a hole on one side in the bearing cups in the middle, and used a punch to push the oposit bcup through the hole that goes through the U joint cross. You can also bank on the cups; /html/spridgets/2007-09/msg00599.html (8,376 bytes)
3. Re: [Spridgets] universal joint (score: 1): Author: "David Lieb" <dbl@chicagolandmgclub.com>; Date: Mon, 24 Sep 2007 08:36:51 -0500; Or use appropriately sized sockets in a vice to press it out. _______________________________________________ Edit your replies http://www.team.net/archive http://autox.team.net/mailman/listinfo/spr; /html/spridgets/2007-09/msg00601.html (7,088 bytes)
4. Re: [Spridgets] universal joint (score: 1): Author: "Dave G." <dmg@bossig.com>; Date: Mon, 24 Sep 2007 17:16:18 -0700; I've usually had good success using a deep socket, the U-joint and a good As long as the cup that doesn't have the socket is on the clear. The cup usually comes out quite a bit and then I use a BIG v; /html/spridgets/2007-09/msg00621.html (7,234 bytes)

Current List: 1 - 4
Page: [1]